This list must be followed carefully each time a battery is connected to the charger.
The charging cable is cable-tied to the charger and you must not remove this cable. The charging lead is terminated with 4mm bullet connectors, which present a very high risk of shorting the battery if removed from the charger.
Do not attempt to charge your battery if any of the cables are lose or frayed. Contact us immediately if you think there’s an issue!
Start/Enterto select the “LiPo balance” charging mode.
Start/Enterto edit the charging current.
Inc./Dec.buttons until it reads 2.2A. Press
Start/Enterto store the value and to begin editing the battery voltage. Use the
Inc./Dec.buttons until it reads 11.1V(3S).
Start/Enterfor three seconds to confirm. The charger will try to detect the battery.
Start/Enterto start charging.
The important thing to note here is that the number of cells detected by the charger (R) and the number of cells set by you (S) are both 3. If either of these numbers are different immediately power down the charger and contact us.
The screen shows the charging current, the current voltage, the time elapsed and the energy provided to the battery.
The “LiPo charge” mode will also fully charge your battery and is usually somewhat faster than “LiPo balance”; however it shortens the lifespan of the battery. We highly recommend using balance mode unless you desperately need the battery to be charged sooner.
The charger will beep when the battery is fully charged. You must then:
Stopbutton. The beeping should now stop.
This process is also the same if you want to stop charging part-way through.
Start/Enter. You can then press the
Inc./Dec.button until it shows the “LiPo balance” mode.